電熱水鍋爐廠家介紹說濕法保養一般適用于停爐時間不超過一個月的鍋爐的保養，那么應該如何對電熱水鍋爐進行濕法保養呢？

1、電熱水鍋爐廠家http://www.tncttc.com/談到停爐后按規定時間放盡爐水，將水垢、水渣、煙灰清除干凈，關閉所有的人孔、手孔、閥門等，與運行的鍋爐完全隔絕。
Speaking after the electric water boiler manufacturers shutdown stipulated time exhausted furnace water, scale, slag, ash cleaned off all the manholes, hand holes, valves, etc., and run the boiler completely isolated.

2、電熱水鍋爐廠家介紹用合格軟化水配制堿性保護溶液，按每噸爐水加入氫氧化鈉或加碳酸鈉或加磷酸鈉，用專用泵將配制好的堿性保養溶液注入鍋爐。
Electric water boiler manufacturers introduced softened by a qualified basic protection solution preparation, boiler water per ton plus sodium hydroxide or sodium carbonate or sodium phosphate plus, with a special pump the prepared alkaline solution is injected into the boiler maintenance.

3、電熱水鍋爐廠家談到當保護溶液全部注入后，開啟給水閥將合格軟化水注滿鍋爐，直至水從空氣閥溢出為止，然后再關閉空氣閥和給水閥，開啟專用泵循環，使溶液混合均勻。
Electric water boiler manufacturers when it comes to the protection of all the injected solution, the valve will open to qualified demineralized water filled boiler until the water overflows from the air valve, and then close the air valve and the valve to open a dedicated pump cycle, ensure thorough mixing .

4、電熱水鍋爐廠家http://www.tncttc.com/提醒在整個保養期間，應定期用微火烘爐保持受熱面外部干燥，定期開啟泵循環，使各處溶液濃度一致，還要定期取溶液化驗和補充藥液，使溶液PH值在10~12之間，保證爐水的堿度，但是在冬季要采取相應的防凍措施。
Electric water boiler manufacturers throughout the maintenance period reminders should maintain regular external heating surface dry with Weihuo oven, turn the pump on a regular cycle, so consistent throughout the solution concentration, but also regularly take supplementary tests and liquid solution, the solution PH value between 10 to 12, to ensure that the boiler water alkalinity, but in the winter to take appropriate measures in antifreeze.